Australian/New Zealand Luthiers Forum

very nice indeed , nice maple on the neck, did you stain the fingerboard?
regards
chris

Have Knovo guitar and uke (tenor size), both work fine, both have Temp control but I also always use a seperate thermocouple (temp gauge) that you will find in a lot of multi meters (JayCar)

https://www.facebook.com/chris.clarke.5 ... 891128501/

https://www.facebook.com/chris.clarke.5 ... 813566562/

hard shellac and tiger myrtle

Did you try lighter gauge strings?

https://esomogyi.com/pricing/ for this much you can have all the pointy bits you want

its red gum burl, from Maleny I put it in upside down could not see the joins on the other side but got excited and put it in the wrong way. Once in couldnt get it out.
regards
chris

Building 2 Guitars both Engleman spruce tops (as well as some ukes)
1 EIR B/S
1 High Figure Blackwood B/S

my copy turned up yesterday, have thumbed through it and is impressive work. thank you.

http://pacificrimtonewoods.com/wp-conte ... Report.pdf

for information purposes
regards

https://www.youtube.com/watch?v=HRB8EypxVPU
this works very well and if you have a hollow in middle the sandpaper on a level works really well to flatten out the edge till flat
regards
chris

thats beautiful

https://www.facebook.com/beauhannamguit ... =3&theater

https://www.facebook.com/beauhannamguit ... =3&theater

these may be of interest

spectrum analyzer on samsung

Thanks for the ideas

Hello All, I was after thoughts on flat sawn timber for SS acoustic necks. I have received some nicely figured blackwood in a size that suits being made into a couple of necks, however it is flatsawn. Is this ok if you use carbon reinforcing rods in the neck? Any thoughts would be appreciated. regar...

Using the hard shellac on some ukuleles with blackwood B/S and sitka and Bearclaw tops https://www.instagram.com/p/BnfBK3rlKwe/ https://www.instagram.com/p/BnfG74AlY9f/?taken-by=kala4561 https://www.instagram.com/p/BnfI1NIHL8I/?taken-by=kala4561 https://www.instagram.com/p/BnfLY-KF_R8/?taken-by=kala...

made this, and did that, very easy to use and very small adjustments quickly thanks Trevor Gore

thanks trevor

hello Trevor
thanks for the pictures, does the aluminium bar closest to the adjusting knob (with fancy inlay) have a threaded hole, or is the adjustment achieved in another fashion
thanks for your time
regards
chris

thank you,
your a good man
regards
chris

Hello trevor, hope you had a good trip, Just re-measured and its 378 across the lower bout, I see their website they are 368. so maybe this is 00@1/2 somewhere between the 00 and 000. Beautiful sounding instrument if we can get close to the quality of sound it would be very pleasing. Just looking at...

similar to rosette making i have seen, and if you like planes this bloke has a lot. video starts at :30 secs

https://www.youtube.com/watch?v=TxvOMHoLRBY