I was just about to glue my copies of my plans to cardboard to make templates when I wondered of it would be better to use my A4 laminator.
It would make them stiffer and I could draw on them.
Then I wondered if I could use my laminator as a heat source alongside a dowel jig as a side bending setup.
Since the thermostat packed in it seems to gt hot enough.
A4 laminated templates or laminator/ side bender?
A4 laminated templates or laminator/ side bender?
Martyn
The glass is half full... but I'll have another while your up!
It's not over until Ricky Pontin cries! (Not long now).
Great minds like a think!
The glass is half full... but I'll have another while your up!
It's not over until Ricky Pontin cries! (Not long now).
Great minds like a think!
Who is online
Users browsing this forum: No registered users and 146 guests