Fret seating problem

Talk about musical instrument construction, setup and repair.

Moderators: kiwigeo, Jeremy D

Posts: 164
Joined: Tue Dec 31, 2013 7:10 pm
Location: Canberra

Re: Fret seating problem

Post by Fisherman » Wed Jan 16, 2019 6:02 pm

I had some trouble with an ebony board on the last guitar. I cut the slots a couple of days before hammering in frets and they wouldnt go in when I got to the job. I had to recut again just before hammering them in (but they stayed ok after that). So perhaps the precut board u bought closed up a bit, maybe also because of glueing it to the neck before hammering in frets? Hard to say.

I havent had any issues with rosewood and ebony was ok the previous guitar.

Posts: 399
Joined: Sun Oct 26, 2008 2:27 pm
Location: Melbourne (Ringwood), Australia

Re: Fret seating problem

Post by vandenboom » Thu Jan 24, 2019 9:28 am

Tajima pull saw is available from total tools and ebay for abour $35. Blades are replaceable and come in several thicknesees. Saw comes with 265 blade and i use it for most of my hand saw jobs. The 230 is .023" so good for fretting.
I cut my slots with stewmac blade in a single pass but find they can still be a bit tight on some woods so run the tajima 230 through each slot to open it up a smidgeon more. Your pre-slotted board may be in this category. ... CyEALw_wcB

Posts: 99
Joined: Sat Oct 27, 2007 4:09 pm
Location: NZ (Palmerston North)

Re: Fret seating problem

Post by Richardl » Mon Feb 04, 2019 11:02 am

Thanks all, slots made deeper and a bit wider and re-fretted. Guitar finished and sounds good. :D


Post Reply

Who is online

Users browsing this forum: Crafty Fox and 27 guests