Neck bolt bar dimensions

You can ask questions here about Trevor and Gerard's exciting new book on Luthiery.

Moderators: kiwigeo, Jeremy D

Post Reply
User avatar
kiwigeo
Admin
Posts: 10579
Joined: Sat Sep 29, 2007 5:57 pm
Location: Adelaide, Sth Australia

Neck bolt bar dimensions

Post by kiwigeo » Tue May 14, 2013 11:04 am

Trevor,

When you discuss the neck bolt bar and the mortised hole for same you use imperial and metric dimensions for the former and latter respectively...ie and 3/8" square brass bar (first para section 14.6) and 10mm hole (second to last para of section 5.3.1).

Am I ok to use both a 10mm metric bar and 10mm mortiser bit?
Martin

User avatar
Trevor Gore
Blackwood
Posts: 1605
Joined: Mon Jun 20, 2011 8:11 pm

Re: Neck bolt bar dimensions

Post by Trevor Gore » Tue May 14, 2013 2:23 pm

Simple answer, yes.

The detail is, as ever, more complicated. The easily available dimensioned bar stock is 3/8" in brass and 10mm in aluminium. The easily available mortisers are 3/8". Due to manufacturing tolerances etc. none of these options will provide a fit - you won't be able to get the bar in the hole. The simplest route is to reduce the bar a little (file, belt sander, drum sander, whatever) and the easiest material to work (unless you have a milling machine) is the brass. So relieve the brass a little and all is good.

If you can get a 10mm mortiser bit, you should be good to go straight away with the 3/8" brass (9.5mm). You'll likely find the 10mm aluminium too tight a fit.

Word of warning, though: Just because someone advertises a 10mm mortiser doesn't mean it's not actually a 3/8" one, so make sure you're buying what you think you're buying.

User avatar
kiwigeo
Admin
Posts: 10579
Joined: Sat Sep 29, 2007 5:57 pm
Location: Adelaide, Sth Australia

Re: Neck bolt bar dimensions

Post by kiwigeo » Tue May 14, 2013 5:53 pm

Thanks Trev.
Martin

User avatar
Allen
Blackwood
Posts: 5251
Joined: Thu Oct 11, 2007 5:39 pm
Location: Cairns, Australia
Contact:

Re: Neck bolt bar dimensions

Post by Allen » Thu May 16, 2013 5:54 am

While metal might come specified as a certain dimension, it's best not to assume it will be either. You only have to buy some from different sources and put a set of micrometers on them to find that there can be an astonishing degree of variations to what you thought you bought.
Allen R. McFarlen
https://www.brguitars.com
Facebook
Cairns, Australia

Post Reply

Who is online

Users browsing this forum: No registered users and 10 guests